Re: Status pin clarification
Posted: Sat Jan 11, 2014 12:22 pm
Your INO file as posted looks good. Have you looked at the RelayShield's jumper settings ?
I'd try uploading another program (other INO) file to your Arduino to have the boards tested out in a more straight forward
simplistic context. For example, use the simple INO program provided with the DFRobot RelayShield, found on their
documentation Wiki page.
Again, go baby steps. Remove all wires and start with simply the NC1/COM1 connections without anything else, and only
when that part works, move on to the next stage ...
Best regards,
I'd try uploading another program (other INO) file to your Arduino to have the boards tested out in a more straight forward
simplistic context. For example, use the simple INO program provided with the DFRobot RelayShield, found on their
documentation Wiki page.
Again, go baby steps. Remove all wires and start with simply the NC1/COM1 connections without anything else, and only
when that part works, move on to the next stage ...
Best regards,