Port forwarding - Netgear WNR2000
Posted: Wed Jan 28, 2015 8:21 am
Hi folks,
Just in the midst of setting this up and I cant get it to work from the internet side. I do have it triggering nicely from the local network side.
I'm a bit new to this port forwarding caper, so I have probably have made some kind of rookie error.
I am using an xboard relay for the arduino side and my router is a WNR2000
I have also tested the port on www.canyouseeme.org..... not getting through
In the router....
1. WAN Setup => Changed NAT filtering from Secured to open
2. Port Forwarding/Port Triggering => Added an FTP port
(Changed Service Name to HTTP still no worky)
3. LAN Setup => reserved an ip address for the arduino
Like I said ... internal connection via wifi works fine.....but the internet port forwarded connection is giving me grief.
Any assistance greatly appreciated... thanks
PTB
Just in the midst of setting this up and I cant get it to work from the internet side. I do have it triggering nicely from the local network side.
I'm a bit new to this port forwarding caper, so I have probably have made some kind of rookie error.
I am using an xboard relay for the arduino side and my router is a WNR2000
I have also tested the port on www.canyouseeme.org..... not getting through
In the router....
1. WAN Setup => Changed NAT filtering from Secured to open
2. Port Forwarding/Port Triggering => Added an FTP port
(Changed Service Name to HTTP still no worky)
3. LAN Setup => reserved an ip address for the arduino
Like I said ... internal connection via wifi works fine.....but the internet port forwarded connection is giving me grief.
Any assistance greatly appreciated... thanks
PTB