Page 2 of 2

Re: Help configuring IDE software

PostPosted: Sat Jan 04, 2014 9:30 pm
by support
From the link we provided in our previous post ...
On Windows, it would be My Documents\Arduino\libraries\.

We're no Windows expert, but from your PDF, it looks like you have the files in ...\Libraries\Documents\arduinio-1.0.3\...

Create an "Arduino" folder structure in "My Documents" and move all the data files from
our ZIP archive in there, as suggested in the link we provided and it should work ...

Best regards,

Re: Help configuring IDE software

PostPosted: Mon Jan 06, 2014 2:06 am
by jono
Making progress.
While verifying on the Arduino IDE software editor I received the attached response.... I believe it's showing an error.
Unsure of this, I did download the software to the Arduino board, connected to my ethernet (without connecting my sensors) and tried locating the IP address on my browser. I was unable to successfully connect to that page. I'm unsure if this is because I have not connected the sensor and status wires, but I suspect not.

Any advice is greatly appreciated!
Thanks,
Jon

Re: Help configuring IDE software

PostPosted: Mon Jan 06, 2014 8:59 am
by support