Moving right along…
I made the change to port 81. Compiled and uploaded without errors.
I filled in all the blanks in the MDO iPhone software and everything checked out fine.
*********************************************************************************************************************
IMPORTANT FIND FOR EVERYONE ELSE
When you enter the URL in the MDO software, you MUST list the port number after the URL.
If you don't you will get an error that says "Response Parsing Error"
Make sure the URL line is set up like this http://xxxx.noip.com:81/
My url was with no-ip.com and my port is 81 Make sure you change it to what yours actually is.
*********************************************************************************************************************
My computer is actually in my garage, so I am sitting here with the garage door open as I do all this.
I launch the MDO software. It refreshes and shows a green light with a picture of my open garage door.
I hit the picture and the close button comes up. I hit close and BANG my door closes!! Awesome!!
Not so fast. As soon as the door is closed, my Arduino and the Relay board and the AC adapter start the flashing like they did in the
beginning in the video I posted.
The problem occurs when the door sensor is made. So somewhere in that area of the circuit lies my problem.
Faulty sensor? No. UNLESS, I have the sensor on the wrong pins? Take a look at the attached picture.
Thoughts?
I am so close I can taste it.