Reset required after a power on?

General support questions and discussions.

Reset required after a power on?

Postby slime » Fri Jul 31, 2015 6:19 am

My board sometimes stops responding after a few weeks, so I have put a remote controlled (internet) socket on the PSU plug. I can now reboot my UNO, but the mydoor opener app doesn't respond after a power off of the uno - it seems to need a power on and then a reset.

Any ideas why?

Thanks,
Si.
slime
 
Posts: 5
Joined: Tue Jun 09, 2015 10:13 am

Re: Reset required after a power on?

Postby support » Sun Aug 02, 2015 9:17 am

You shouldn't need to reboot your board in the first place. Typically, you have a faulty board or something. Ours has been turned ON forever and the only time it gets a power cycle is when there's a power outage. I'd look into replacing the board if I were you.

Best regards,
support
Site Admin
 
Posts: 384
Joined: Thu Aug 22, 2013 7:30 pm

Re: Reset required after a power on?

Postby slime » Tue Aug 11, 2015 3:53 am

Thanks - OK, I swapped the power supply (to a POE injector and POE switch) and changed the back end to 2.4 (was running 2.2). It seems much better so far :)

Cheers,
Si.
slime
 
Posts: 5
Joined: Tue Jun 09, 2015 10:13 am


Return to Support



cron