by z0ner » Sun Mar 15, 2015 4:05 pm
Thanks for the quick reply. I actually dug around and found that thread, but I couldn't delete mine because the thread hadn't been approved yet.
I ran into a comedy of errors, now all resolved, which may help some peeps.
#1 I thought the X-Board was defective because of the relays firing every minute. The thread above describes it's a test program that gets loaded at the factory - ergo, not defective.
#2 I tried a few micro-USB to USB cables, but Windows wouldn't see it. I found a thread that mentioned there are actually two types - one primarily for charging, and another for charging + data transfer. I finally found one that Windows finally saw (partially).
#3 I couldn't get the Arduino Leonardo driver to install on my Windows 7 64-bit for anything. I combed the web looking for new drivers, all-in-one drivers, etc. It turned out it was because I was plugging the X-Board into my Dell monitor USB hub, and it was treating it differently than a direct USB. Once I plugged it in directly, it was recognized and I could easily upload the sketch with my changes.
I have a sensor to pick up on Monday, and then out it goes to the garage. I've already punched a hole in my firewall and tested it using the iOS app.
I'm so excited about this project simply because it's much more economical than anything else currently available. Fun little project.