I know this is a silly question but I am not sure of the answer. I have been working on the open my garage door setup and I can not figure out how to program the Chinese knockoff of the Ethernet Shield. Is it programed by attaching the Arduino Uno to the shield to program it with the software then attached to the Relay shield? I have tried the Arduino USB2 serial converter and that seems to be a nonstarter,no pins to plug in to except for the ICSP male pins and the ICSP female pins on the Shield, but It seems to me the pins do not match the pinout. I looked for a programer cable to plug into the ICSP on the Ethernet shield but no and I also tried to make my own cable but it does not seem to work either. Besides this problem and the wait for parts the project seems to be moving forward. I would appreciate any help to get this project up and running. Also I have got the shield up and running when attached to the Arduino uno board and my computer does see it.
John M