Help configuring IDE software

General support questions and discussions.

Re: Help configuring IDE software

Postby support » Sat Jan 04, 2014 9:30 pm

From the link we provided in our previous post ...
On Windows, it would be My Documents\Arduino\libraries\.

We're no Windows expert, but from your PDF, it looks like you have the files in ...\Libraries\Documents\arduinio-1.0.3\...

Create an "Arduino" folder structure in "My Documents" and move all the data files from
our ZIP archive in there, as suggested in the link we provided and it should work ...

Best regards,
support
Site Admin
 
Posts: 384
Joined: Thu Aug 22, 2013 7:30 pm

Re: Help configuring IDE software

Postby jono » Mon Jan 06, 2014 2:06 am

Making progress.
While verifying on the Arduino IDE software editor I received the attached response.... I believe it's showing an error.
Unsure of this, I did download the software to the Arduino board, connected to my ethernet (without connecting my sensors) and tried locating the IP address on my browser. I was unable to successfully connect to that page. I'm unsure if this is because I have not connected the sensor and status wires, but I suspect not.

Any advice is greatly appreciated!
Thanks,
Jon
Attachments
MDO-2.jpg
MDO-2.jpg (49.19 KiB) Viewed 2308 times
jono
 
Posts: 7
Joined: Mon Dec 30, 2013 11:59 am

Re: Help configuring IDE software

Postby support » Mon Jan 06, 2014 8:59 am

support
Site Admin
 
Posts: 384
Joined: Thu Aug 22, 2013 7:30 pm

Previous

Return to Support



cron