Probably time to review my situation.
My controller opens / closes a door and sets / unsets my house alarm. It works and my phone shows appropriate open / close confirmations for both functions.
I have discovered that push notifications work perfectly and immediately for alarm unsets but whilst door open confirmations occur correctly push notifications do not.
I have tried the same setup on three controllers using different copies of the sketch to reflect different IP and mac addresses but they are all based on your last release of the code.
I have also set up a control to control other relays to simulate door open / close and push does not work.
I have also tried different analogue in pins and the result is always the same. ie alarm push notification works and door open does not.
The only other thing I can say is that I always get a push notification each time a controller is reset or I open serial debug.
Can you shed any light on this?
Thanks and regards,